.....then connect the gray cable into the 'combiner' box.......
Using Tom's heat gun to shrink the insulation onto the cable
.....things moved steadily all daylong until we were, at last, working on the fourth, and final solar panel......
.....now that all four gray cables have been cut to length, and connected to the 'combiner' box it is time to drill a hole in the roof, and begin to run the black and red cable down to the location of the charger controller, which will be under the salon couch....
Just drilled the 1 1/8" hole for the red and black cable
.....once we were done with the 'combiner' box I broke out the DICOR self leveling lap sealant to squeeze some onto each 'foot' to further secure each 'foot' to the Newell roof.....
....we then fed the cable down the refrigerator chimney........
.....and then into the cabinet below the floor of the refrigerator chimney.....
.....at this point Laureen and Glenn took over to finish running the cable to the area under their couch where we will connect it to the Victron charge controller......↴
Looks good to see those solar panels up there
......while all that fun was in progress Tom was under the Newell removing the final 6 air bags in preparation the installation of of the new ones when they arrive Thursday, or Friday.....
......Wednesday was also Tom's birthday so we convened in the 'mancave' around 6:15 for mini pizzas....
Thanks for stopping by!
When you shop Amazon, please use our link (below) to access their website.......we will appreciate every purchase you make using our Amazon Affiliate link, and remember, using our link will not add one penny to your purchase, plus we will receive a small commission which over the course of a year adds up to enough to by a tank of diesel for which we thank you very much!
No comments:
Post a Comment
Note: Only a member of this blog may post a comment.